Truco para instalar poceta en tubos de drenaje #fyp #videoviral

if you need to install a pump, first make sure that the drainage tube is not cut to the ground it is essential that it always comes out at least a centimeter so that it serves of guide and anchor to the seal then you have to be careful about the edges of this tube to eliminate waves and guarantee a completely smooth contact surface Once prepared, the sealant is removed, around the tube base and in the technical holes of the linoid base to block any humidity gap then take the expansion tube and place 2 silicone rings in its lateral rations to create a pressure barrier, apply a generous stainless steel cord on the upper edge of the tube and press against the output of the linoid base Put the piece on the tube of 1 cm and leave the weight of the porcelain compresses Finally, remove immediately the deposit to verify that the silicone rings are not dead or displaced and after confirmation it goes back to fit it firmly making it in this way a professional installation and free filtering for decades now give me a like and follow me